Agilent Technologies 4352B, Service Manual

Page: 277 / 293

Error Messages (Alphabetical Order)
132 CAN'T S A VE GRAPHICS WHEN COPY IN PROGRESS
If you attempt to save graphics when a print is in progress , this error message is displayed.
W ait until the print is completed, then save the graphics again.
0281 Cannot create program
Indicates that an attempt to create a program was unsuccessful. A reason for the failure might
include not enough memory .
54 Carrier Overload
The carrier level in a C/N ratio measurement or a phase noise measurement is too large .
The 4352B RF IN connector's input level is too large . V erify the input level to the 4352B RF IN
connector .
0140 Character data error
This error , as well as errors 0141 through 0148, are generated when analyzing the syntax
of a character data element. This error message might be displayed if the 4352B detects an
unknown problem.
0148 Character data not allowed
A legal character data element was encountered where prohibited by the 4352B.
0144 Character data too long
The character data element contains more than twelve characters (see IEEE 488.2, 7.7.1.4).
0100 Command error
This is a generic syntax error that the 4352B displays when it cannot detect more specic
errors . This code indicates only that a command error , as dened in IEEE 488.2, 11.5.1.1.4, has
occurred.
0110 Command header error
An error was detected in the header . This error message might be displayed if the 4352B
detects an unknown problem related to errors 0111 through 0119.
77 DC Control Current Overload
The current through the DC CONTROL connector is too large (20 mA or more).
P ossible problems and the corrective action are shown below:
The DUT's control current is too large .
V erify that the DUT is correctly connected to the 4352B RF IN connector .
An eect of the high value capacitor connected to the DUT's power voltage (V
cc
) terminal.
This is a transient error . Press 4 DC Control 5 ,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
CTRL DELAY , and the entry keys to set a
suciently large value for elimination of this transient error .
Messages-4