Agilent Technologies 4288A, Programming Manual

Page: 241 / 289

Appendix B 239
Information for Replacing 4278A with 4288A
At-a-Glance List of GPIB Command Correspondence
B. I
n
for
m
a
tio
n fo
r Repl
ac
in
g
427
8A
wit
h
42
88A
DSTD= Sets the D value of the standard for the standard (LOAD) compensation. :CORR:CKIT:STAN3 on page 155
DTIM= Sets the delay time (trigger delay time). :TRIG:DEL on page 195
DVAL{1|2} Sets the display mode. :CALC1:MATH:EXPR:NAME on page 148
[ E ]
ERR? Reads out the error message number. :SYST:ERR? on page 192
[ F ]
FREQ{1|2} Sets the measurement frequency. :SOUR:FREQ on page 187
[ G ]
GSTD= Sets the G value of the standard for the standard (LOAD) compensation. :CORR:CKIT:STAN3 on page 155
[ H ]
HIAC{0|1} Turns ON/OFF the HI-ACC mode. N/A
[ I ]
ITIM{1-3} Sets the integration time (measurement time). :APER on page 130
[ L ]
LMOD{1-3} Sets the limit mode (limit range specification method). :CALC:COMP:MODE on page 141
LOAD Loads (recalls) the measurement condition. *RCL on page 126
LPAR{1-6} Sets the parameter to be sorted by the comparator. N/A (Dependent on the measurement
parameter and cannot be set up separately.)
[ M ]
MCOM{0|1} Turns ON/OFF multi-compensation. :CORR:MULT on page 161
MPAR{1-6} Sets the measurement parameter. :CALC1:FORM on page 147,
:CALC2:FORM on page 150
[ N ]
NOM= Sets the nominal value (reference value) in the tolerance mode. :CALC:COMP:PRIM:NOM on page 144
[ O ]
OFFA= Sets the offset compensation value for the primary parameter. :CORR:OFFS:DATA on page 164
OFFB= Sets the offset compensation value for the secondary parameter.
OPEN{0|1} Turns ON/OFF the OPEN compensation. :CORR:OPEN on page 165
OPM? Reads out the measured OPEN compensation value (data for OPEN
compensation). :CORR:DATA on page 158
OSC= Sets the OSC level (measurement signal level). :SOUR:VOLT on page 188
[ R ]
RA{0-7} Sets the measurement range when the measurement frequency is 1 kHz. :RANG on page 184
:RANG:AUTO on page 185
RB{0-11} Sets the measurement range when the measurement frequency is 1 MHz.
RC= Sets the measurement range value for the HI-ACC mode. N/A
RCNT Resets the BIN count value. :CALC:COMP:COUN:CLE on page 137
REVP{0|1} Turns ON/OFF the reverse parameter function. N/A
[ S ]
Table B-25 At-a-glance list of GPIB command correspondence between 4278A and 4288A
(alphabetical order)
4278A Function overview 4288A