39
:Anapurna H3200i LED Advanced Operator Manual (v1.0)
4.6.4
Margins
4.6.4.1 Rigid media
Left:
The scale on the ruler of the media set bar corresponds with the calibration of the printer pro-
gram and starts measuring at the beginning of the media transport.
When you want to start printing on the edge of the media, you enter the distance (in mm) of the
left edge of the rigid on the ruler (e.g. 50 mm in the figure shown above).
When you want to have a white border, add the desired width (in mm) of the border to the dis-
tance of the left edge on the ruler (e.g. 90 mm (50 mm + 40 mm border) in the figure shown
above).
Top:
When you want to start printing on the edge of the media, you enter 0.
When you want to have a white border, add the desired width (in mm) of the border (e.g. 30 mm
in the figure shown above).
Right:
The UV LED units may not stop above the media during printing as this may result in distortion
of the media. In this field, enter the distance of the shuttle travel needed to stop beyond the
media, calculated from the print (e.g. 100 mm in the figure shown above).
Skip Home:
Deactivated: the shuttle returns to its home position after every print pass.
Activated: the shuttle stops on the starting point for printing (e.g. 90 mm in the figure shown
above).
Left
Left
Left (with border)
Left (with border)
Top
Top
Shuttle
Home
Skip Home
Right
