www.agfagraphics.com
32
4.5 Control screen
Pressing the Control Tab opens the Control screen.
This screen provides control over the motion and alignment functions of the printer.
No.
Screen field
Refer to
1
Control
Controls of the media transport belt.
4.5.1
2
Set
Sets the language and system.
4.5.2 & 4.5.3
3
Print Alignment Patterns
There are four types of calibration patterns; Prime, Horizontal, Feed and
Bidirectional. These are printable patterns that may be used to verify the
accuracy of the print head alignment.
Each test pattern gives numerical feedback that allows the operator to
adjust the settings in the relevant calibration tables.
Each button opens a pop-up from which the calibration patterns may be
printed, and from which the calibration table may be opened to adjust the
timing parameters.
Chapter 7
4
Alignment Parameters
Controls the position of the test prints using the left and top margin, the
speed of the shuttle (Carriage Speed) and the use of the UV LED units.
--
5
Maintenance
Controls the hardware features of the printer or gives access to panels
where maintenance tasks may be performed.
Chapter 10
6
Exit
Allows you to exit the application (PC stays on).
--
7
Information bar
gives information about:
- the area humidity (%) and temperature (°C).
- the actual Gap set and media thickness.
Note: if the gap set is not performed, no values are shown..
--
