Aficio c7528n, Setup Manual

Page: 374 / 660

Monitoring and Configuring the Printer
234
msh> set http
msh> set rendezvous
msh> set nbt
msh> set ssdp
msh> set parallel
msh> set bluetooth
msh> set usb
msh> set device
❖
Configuration
• Enter “up”to enable protocol, and enter “down” to disable protocol.
You can set the protocol to “active” or “inactive”.
msh> set tcpip {up | down}
• If you disable TCP/IP, you cannot use remote access after logging off. If
you did this by mistake, you can use the control panel to enable remote ac-
cess via TCP/IP.
• Disabling TCP/IP also disables ip1394, lpr, ftp, rsh, diprint, web, snmp, ssl,
ipp, http, and rendezvous
msh> set appletalk {up | down}
msh> set netware {up | down}
msh> set smb {up | down}
msh> set scsiprint {up | down}
• scsiprint is available when the optional IEEE 1394 interface board is in-
stalled.
msh> set pictbridge {up | down}
• pictbridge can be specified only when the pictbridge is installed.
msh> set ip1394 {up | down}
• ip1394 can be specified only when the IEEE 1394 interface is installed.
msh> set lpr {up | down}
msh> set ftp {up | down}
msh> set rsh {up | down}
msh> set diprint {up | down}
msh> set web {up | down}
msh> set snmp {up | down}
msh> set ssl {up | down}
• If Secured Sockets Layer (SSL, an encryption protocol) function is not
available for the printer, you cannot use the function by enabling it.
msh> set nrs {up | down}
msh> set rfu {up | down}