Decommissioning, disassembly, disposal
Assembly instructions EN
SG-50
Edition 01/2021
Rev. 2.0
35–40
10 Decommissioning, disassembly, disposal
The servo gripper must be properly dismantled after use and disposed of in an
environmentally friendly manner.
10.1 Safety instructions for decommissioning and disposal
10.2 Decommissioning
If the servo grippers are not used for a longer period of time, they must be
properly commissioned and stored as described in
chapter 4.5.
10.3 Disposal
The servo gripper must be disposed of properly at the end of their service life
and the raw materials used must be recycled. Observe the legal regulations and
company requirements.
The servo gripper must not be disposed of as a complete unit. Dismantle the
servo gripper and separate the various components according to type of
material and dispose of them properly:
Scrap the metallic materials.
Hand over plastic parts for recycling.
Sort the rest of the components by their material properties and dispose of
them accordingly.
WARNING
Risk of injury due to improper decommissioning and disposal!
Improperly carried out activities can result in considerable material damage
and serious injury.
Only use trained specialist personnel to carry out the activities.
Disconnect the media supply (electrics, pneumatics) before removing the
modules!
Only remove the servo gripper when the control unit is switched off and
secured!
NOTICE
Risk to the environment due to incorrect disposal of the packaging
material of the servo gripper!
Environmental damage can be caused by improper disposal of the servo
gripper.
Electronic parts, electrical scrap, auxiliary and operating materials must
be disposed of by approved specialist companies.
Information on proper disposal can be obtained from the responsible local
authorities.
