AEROEL s.r.l. - PRADAMANO (UD) - ITALY
14
B2798_E 1.1, 2016-04-08
Attention!
The positioning of the fixture must be done in order to allow easy access for the measurement without
risks for the operator. For instructions, please contact the customer service Aeroel
Attention!
For the dimensions of the mounting holes see drawing in Appendix
SEE APPENDIX
For the measuring mode using the fixture
PLEASE REFER TO CHAPTER 3.6 ON-LINE MEASUREMENT WITH FIXTURE DEVICE (OPTIONAL)
2.6
PULLEY SET FOR WIRE GUIDANCE, WITH ADJUSTING WHEEL (OPTIONAL DEVICE)
The fixture for the on-line measurement (optional) can be completed with a pulley set (optional) very useful to centre
and guide the wire (see figure)
Fixing
rail
Wire guiding
pulleys
Presetting
wheel
Gun
holder
Wire to be
measured
The wire guiding system is composed by
•
1 rail type ITEM 6 30x30 (ITEM 0.0.419.01)
•
Assembly of 2 ceramic pulleys and 1 pre-setting wheel with 6 pre-setting positions (from 0.5 to 5.6 mm wire
diameter). The wheel must be rotated to pre-set the distance from the gun holder following the diameter to
check.
•
Sliding nuts for fixing the assembly to the rail ITEM 6 with M6 screws (ITEM 0.0.419.40)
The rail and the pulley assembly can also be supplied separately
The rail must be fixed on the machine to let the wire be guided by the pulleys. The pre-setting wheel must be rotated
following the diameter of the wire (approximately) and then the gun holder must be fixed to the rail and stop against
the pre-setting wheel, in order to be at the right position. The pre-setting wheel allows 5 mm displacement range (6x
steps by 1 mm, from 0.5 (or smaller) to 5.5 (or greater)
The docking o the components to the rail is made using the nuts (supplied with) sliding in the groove of the rail.