AEROEL s.r.l. - PRADAMANO (UD) - ITALY
16
B2798_E 1.1, 2016-04-08
When the gun holder
is in the right position, lock it
to the rail by fastening the 2 screws
When you change the wire diameter by a significant
amount, loosen the 2 screws
, rotate the pre-setting
wheel
to the new value, position the gun holder
against the pre-setting wheel and fasten again the 2
screws
2.7
FRONT PULLEY FOR WIRE GUIDANCE (OPTIONAL DEVICE)
The front pulley for wire guidance are useful for the quick
centering of the moving products. They can only be used with
electrical cable
They can be used only for the measurement of electric cable or
plastic products (optical fiber, tubes, extruded products, etc..).
They must not be used for the measurement of metal products or
moving products with speed exceeding 300 m/min.
The front pulleys cannot be used with the fixture for on-line
measurement
ATTENTION!
Do not use the front pulley with metal products, with
products moving with speed exceeding 300m/min or
with very high vibrations. In these cases there may be
hazards due to breakage of the measured product,
the break of the instrument, the dragging of the gun,
the expulsion and thrown of objects.
The front pulley are simply fixed to the instrument through the magnets that
are located on the external faces of the optics (lower and upper).
The correct positioning and locking of the protection is also guaranteed by
the holes in which the reference spheres are inserted. (see figure at right).
To unlock the pulley, just pull them out and remove them from the magnet
blocks.
Using the pulleys during the measurement is very simple: the product
(moving or still) is perfectly centered in the measurement field when it is
positioned in the pulleys grooves. At this point start the measurement by
pressing the trigger.
2.8
CHARGING THE BATTERY
HWS.1 is equipped with a rechargeable lithium-ion cell, PANASONIC NCR18650B, 3.6V, 3350 mAh, 12 Wh capacity.
At first use, the battery should be fully charged and you should fully charge the battery before any prolonged use of
the instrument.
The fully charged battery allows continuous operation for about 4 hours.
To preserve the life of the battery, you should avoid deep discharge of the battery.
The battery is nevertheless protected from deep discharge. An integrated protective circuit automatically turns the
device off when the battery is discharged.