Advantech MIC-3393, User Manual

Page: 60 / 86

MIC-3393 User Manual 50
3.1 Introduction
The MIC-3393 fully supports the IPMI 2.0 interface and the PICMG 2.9 R1.0 specifi-
cation. The Renesas H8S/2167 has been implemented as the IPMI controller / Base-
board Management Controller (BMC) to run firmware and collect information. The
MIC-3393 IPMI firmware is sourced from Avocent, a provider of proven and tested
IPMI implementations in a wide range of mission-critical applications. The BMC's key
features and functions are listed below.
! Compliant with IPMI specification, revision 2.0
! Compliant with PICMG 2.9 specification
! Environment monitoring (temperature and voltage)
! Power/Reset control via IPMI chassis command
!
Complete SEL, SDR and FRU functionality
! FRU data capacity: 2 KB
! Provides 4 messaging interfaces
! One serial port
! One LPC interface
! One IPMB channel
!
One LAN channel messaging via sideband NIC for out-of-band management
! Four I2C buses (including IPMB and SMBus) and two optional others
! Firmware Hub flashing and updating over serial port
! One hardware monitor
! One interrupt input
! Sensors threshold configuration
! Complete IPMI watchdog functionality (reset, power down, power cycle)
! Platform even filtering (PEF) and alert policies
! External Event Generation
3.2 Definitions
! BMC - (Baseboard Management Controller): This is the common abbrevia-
tion for an IPMI Baseboard Management Controller.
! IPMB - (Intelligent Platform Management Bus): A protocol defined for pass-
ing IPMI messages over a public I2C bus.
! IPMI - (Intelligent Platform Management Interface): A standardized system
management interface. Please refer to the IPMI Specification for more details.
! IPMIv2.0: Specifically version 2.0 of IPMI
3.3 IPMI Function List
The following standard IPMI commands are supported.
These command codes are compliant with the IPMI specification. Mandatory and
Optional commands are defined in the IPMI specification.
For more details, please refer to the IPMI specification.
Note! The Network function (NetFn) field identifies the functional class of the
message. The Network Function clusters IPMI commands into different
sets. Please refer to the IPMI specification of network function codes for
more information.