Mechanical installation
© by DLoG GmbH
DLT-V6210 Manual V1.00
Page 21 / 61
7.3.
Attach the mounting with the VESA mounting hole pattern
The back of the DLT-V6210 has a VESA compatible 75 x 75 mm mounting hole pattern. It is used to
attach VESA compatible mountings to mount the vehicle docking station at the deployment location.
ATTENTION: Physical damage
Only use mountings and fastening materials that have been tested and approved by Advantech-DLoG
for the respective DLT- V6210. Otherwise, any DLoG GmbH warranty for this DLT-V6210 system will
be void.
Fig. 7.1: Position VESA drill holes of DLT-V6210
WARNING
Risk of accident during vehicle operation if the mounting of the V6210 becomes loose
and breaks while driving.
Ensure the following when attaching the mounting on the VESA mounting hole pattern:
−
Specialty mechanical knowledge
is required for correct mounting!
−
Use suitable fastening materials.
−
Use suitable screws: Screws that are too long can penetrate the back of the vehicle
docking station and cause irreparable damage. Screws that are too short do not provide
secure mounting.
−
Use suitable washers.
−
Observe the maximum screw-in depth of the hole of the mounting hole pattern:
The recommended screw-in depth of Dx1 always applies (screw diameter x 1).
−
Advantech-DLoG mountings include suitable screws and washers. Please use them (see
examples on next page).
