Command Set
4-48 ADAM 4100 Series User’s Manual
4.6.9
$AAC
Description
Read the status of all DI/O channels
Syntax
$AAC(cr)
$ is a delimiter character.
AA (range 00-FF) represents the 2-character
hexadecimal address which is to be accessed.
C is the set/read the DI/O status command.
(cr) is the terminating character, carriage return (0Dh)
Response !
AAIIIIIIIIIIIIIIOOOOOOOOOOOOOOOO(cr) if the
command was valid.
?AA(cr) if an invalid command has been issued.
There is no response if the module detects a
syntax or communication error, or even if the
specified address does not exist.
! is a delimiter character indicating that valid command was
received.
IIIIIIIIIIIIIIOOOOOOOOOOOOOOOO is defined as te same
$AACIIIIIIIIIIIIIIOOOOOOOOOOOOOOOO
? is a delimiter character indicating that the
command was invalid.
AA (range 00-FF) represents the responding 2-
character hexadecimal address of the digital I/O module.
IIIIIIIIIIIIII is to set the 7 DI channels (every two I characters
mean one channel). Refer command
$AACIIIIIIIIIIIIIIOOOOOOOOOOOOOOOO
OOOOOOOOOOOOOOOO is to set the 8 DO channels
OO=00 DO
Mode.
OO=01 Pulse
Output
Mode.
OO=02 L->H
Delay
Mode.
OO=03 H->L
Delay
Mode.
Summary of Contents for ADAM 4100
