Chapter
4
Chapter 4 Command Set 4-47
(continue $AACIIIIIIIIIIIIIIOOOOOOOOOOOOOOOO)
Response
>(cr) if the command was valid.
?AA(cr) if an invalid command has been issued.
There is no response if the module detects a
syntax or communication error, or even if the
specified address does not exist.
> is a delimiter character indicating that a valid
command was received.
? is a delimiter character indicating that the
command was invalid.
AA (range 00-FF) represents the responding 2-
character hexadecimal address of the digital I/O module.
Example
command: $02C00210440000000020000000000010203(cr)
response: >(cr)
The DI/O channels are set as the following at address 2
II character
mode
0
00
DI Mode
1
21
Counter mode and enable counter record
2
04
Frequency Mode
3
40
Enable Digital Filter
4
00
DI Mode
5
00
DI Mode
6
00
DI Mode
DO channel OO character
mode
0
02
L->H Delay Mode
1
00
DO Mode
2
00
DO Mode
3
00
DO Mode
4
00
DO Mode
5
01
Pulse Output Mod
6
02
L->H Delay Mode
7
03
H->H Delay Mode
Summary of Contents for ADAM 4100
