![background image](http://html1.mh-extra.com/html/advantech/adam-4100/adam-4100_user-manual_2858272067.webp)
Chapter
4
Chapter 4 Command Set 4-27
4.4.16
#AAMKmm
Name
Set Software Filter Enable/Disable
Description
This command configures the
Software
Filter status
(Enable/disable)
of
all Channels for Multiplexing
Syntax
#AAMKmm(cr)
# is a delimiter character.
AA (range 00-FF) represents the 2-character hexadecimal
address which is to be read.
MK represents the configuration
Software
Filter status of
(Enable/disable)
of
all Channels for multiplexing
command.
mm are the two hexadecimal values which are interpreted
as two binary words (4-bit). The first word represents the
status of channel 4-7, and the second word represents the
status of channel 0-3. Value 0 means the channel is
disabled, value 1 means the channel is enabled.
(cr) is the terminating character, carriage return (0Dh).
Response
!AA (cr) if the command was valid.
?AA(cr) if an invalid operation was entered.
There is no response if the module detects a syntax or
communication error, or even if the specified address does
not exist.
! is a delimiter character indicating that a valid command
was received.
? is a delimiter character indicating that the command was
invalid.
AA (range 00-FF) represents the 2-character hexadecimal
address of the analog input module.
(cr) represents terminating character, carriage return (0Dh).
Example
command: $01MK23(cr)
response: !01(cr)
Hexadecimal 2 equals to binary 0010, which enables
software filter of channel 5 and disables channels 4, 6, and
7.
Hexadecimal 3 equals to binary 0011, which enables
software filter channel 0 and 1, disables channel 2, and 3.
Summary of Contents for ADAM 4100
