Advanced LAN Bypass, User Manual

Page: 68 / 82

Advanced LAN Bypass User Manual 58
Figure 4.41 Set the Debug Message Output Level
4.26 ./lbpcu -SBCT
Sets the bypass control type on a specified segment (cf. Section 3.7.9.1).
Example
Figure 4.42 Set the Bypass Control Type on Segment 1
conf[1].seg0_req_iodir: 0, conf[1].seg0_global_wdt_iodir: 0
conf[1].CTRL_offset : 0, conf[1].CTRL_EXT_offset: 0,
conf[1].FLA_offset: 1c
check_conf[2]file data output:
chip: 15228086
bus: 5e
dev: 0
fun: 2
conf[2].chip: 15228086
conf[2].sck: 1
conf[2].cs: 2
conf[2].si: 4
conf[2].so: 8
conf[2].seg0_gpio1en: 0, conf[2].seg0_gpio0en: 10000
conf[2].seg0_gpio1_data: 0, conf[2].seg0_gpio0_data: 40000
conf[2].seg0_gpio1_iodir: 0, conf[2].seg0_gpio0_iodir: 400000
conf[2].seg0_reqen: 0, conf[2].seg0_global_wdten: 0
conf[2].seg0_req_data: 0, conf[2].seg0_global_wdt_data: 0
conf[2].seg0_req_iodir: 0, conf[2].seg0_global_wdt_iodir: 0
conf[2].CTRL_offset : 0, conf[2].CTRL_EXT_offset: 0,
conf[2].FLA_offset: 1c
ID: 15228086 found at bus: 5e device: 0 function: 0
PCI_base_address= 0x805e0000
conf[segment].memory_bar_offset= 0x00000010
base_memory_address_l:b8800000
base_memory_address_h:00000000
fla_base_memory=e
set cs low for fiber bypass
send commands: 00 00
read_write_protocol checksum correct
receive : 01 14 eb
set cs high for fiber bypass
Firmware version: 01.20
set cs high for fiber bypass
root@localhost:~# ./lbpcu -SBCT
Example: Set bypass control type as copper. So use -SBCT COP-
PER will set the bypass control type as copper.
Command: Set bypass control type.
Syntax: SBCT <segment> <bypass control type>
bypass control type:
COPPER
FIBER
Output: N/A
Error: LBP_ERR_PARAM_OUT_OF_BOUND (0x93)
root@localhost:~# ./lbpcu -SBCT 1 FIBER