Advanced LAN Bypass, User Manual

Page: 61 / 82

51 Advanced LAN Bypass User Manual
Chapter 4
L
BPCU
4.14 ./lbpcu -WT
Sends the WDT start sequence through the toggle pin interface (cf. Section 3.7.5.2).
Example
Strobe/reset the WDT through the toggle pin interface on Segment 1:
Figure 4.23 Strobe the WDT through the Toggle Pin Interface on Segment 1
4.15 ./lbpcu -GLEA
Returns the last event and last action (i.e., the current state of bypass relays) on a
specific segment (cf. Section 3.7.3.3).
Figure 4.24 Usage of the "lbpcu -GLEA" Command
Get the last event and last action on Segment 1:
Figure 4.25 Get the Last Event and Last Action on Segment 1
root@localhost:~# ./lbpcu -WT
Example: Toggle the NIC to strobe/reset the WDT on segment_1.
So use -WT 1 will Toggle the NIC on segment_1.
Command: Toggle the NIC
note: Toggle pin WDT mode needs to be enabled & armed.
Syntax: WT <segment>
Output: N/A
Error: LBP_ERR_PARAM_OUT_OF_BOUND (0x93)
root@localhost:~# ./lbpcu -WT 1
root@localhost:~# ./lbpcu -GLEA
Example: last event and last action on segment_1 are POWER_ON
and CONNECT. So use -GLEA 1 will get POWER_ON and CONNECT out-
put.
Command: Get last event and action
Syntax: GLEA <segment>
Output: Last event and last action.
Error: LBP_ERR_PARAM_OUT_OF_BOUND (0x93)
root@localhost:~# ./lbpcu -GLEA 1
last event: WATCHDOG_TIMEOUT
last action: DISCONNECT