Advanced LAN Bypass, User Manual

Page: 75 / 82

65 Advanced LAN Bypass User Manual
Chapter 4
L
BPCU
4.39 ./lbpcu -WAT
Sends the WDT start sequence through the toggle pin interface of all segments (cf.
Section 3.7.5.2).
Example
Strobe/reset the WDT through the toggle pin interface on all segments:
Figure 4.56 Strobe the WDT through the Toggle Pin Interface on All Segments
4.40 ./lbpcu -SACA
Manually sets an action on all segments (cf. Section 3.7.3.4):
Figure 4.57 Usage of the "lbpcu -SACA" Command
Example
Manually set the BYPASS action on all segments manually and then use the "lbpcu -
GLEA" command to check the last event and last action on Segments 1 and 2:
Figure 4.58 Set the Manual BYPASS Action on All Segments
root@localhost:~# ./lbpcu -WAT E
Example: Toggle the NIC to strobe/reset the WDT on all seg-
ments. So use -WAT will Toggle the NIC on all segment.
Command: Toggle the NIC
note: Toggle pin WDT mode needs to be enabled & armed.
Syntax: WAT
Output: N/A
Error: LBP_ERR_PARAM_OUT_OF_BOUND (0x93)
root@localhost:~# ./lbpcu -WAT
root@localhost:~#
root@localhost:~# ./lbpcu -SACA
Example: Set BYPASS action on all segments. So use -SACA
BYPASS will change all segments' action to BYPASS immediately.
Command: Set current action
Syntax: SACA <action>
Output: N/A
Error: LBP_ERR_PARAM_OUT_OF_BOUND (0x93)
root@localhost:~# ./lbpcu -SACA BYPASS
root@localhost:~# ./lbpcu -GLEA 1
last event: MANUAL
last action: BYPASS
root@localhost:~# ./lbpcu -GLEA 2
last event: MANUAL
last action: BYPASS