www.advancedco.com
31
Dual Switch Monitor Module - 55000-790ADV
The 55000-790ADV Dual Switch Monitor Module is an addressable module for use with the AX-CTL-1L, AX-CTL-2 or
AX-CTL-4 intelligent fire alarm control panel. The Dual Switch Monitor Module incorporates two (2) independent,
individually programmable, initiating device circuits (IDC), providing cost-effective solutions in areas requiring
multiple addresses within the same location. Each initiating device circuit is separately addressed and can be wired
Class A or B. A typical application for the Dual Switch Monitor Module would be the individual monitoring of
waterflow and tamper switches located at a sprinkler system riser.
Incorporated with each individual IDC circuit is a built-in priority interrupt feature which allows rapid response
capabilities from highly critical contact devices (e.g., manual pull stations, etc.). Two (2) eight position programming
DIP switches are provided on each Dual Switch Monitor Module for IDC circuit addressing and wiring classification
definition. The 55000-790ADV mounts to the front of a standard 4” square or 2-gang electrical outlet box. Displayed
on the front of each 55000-790ADV is two (2) red status LEDs which flash when the individual address is polled and
illuminate steady when the IDC circuit is active (see figure 11).
4.2.1.3.1.6.2
Intelligent
Input/Output
Modules
I/O Relay Output & Switch Monitor Module - 55000-820ADV
The 55000-820ADV I/O Relay Output & Switch Monitor Module is an application specific addressable module for use
with the AX-CTL-1L, AX-CTL-2 or AX-CTL-4 AX-CTL base card. Each 55000-820ADV is SLC loop powered
eliminating the need for additional field wiring and external power supplies. Designed for installation on the SLC
(signaling line circuit) the I/O Relay Output & Switch Monitor Module provides a single initiating device circuit (IDC)
input, an independently controlled Form-C relay contact output, and an unmonitored optically isolated voltage input.
The I/O Relay Output & Switch Monitor Module utilizes Advances’ unique sub-addressing for both the independently
controlled relay and the optically isolated voltage input. By sub-addressing 55000-820ADV’s modules, system point
capacities are expanded with installation, programming, and commissioning time minimized. The 55000-820ADV
mounts to the front of a standard 4” square or 2-gang electrical outlet box. Displayed on the front of each 55000-
820ADV is a single red status LED which flashes when the device is polled (see figure 12).
L1
L2
-
+
-
+
To Next
Peripheral
From
SLC Loop
Programming
DIP Switches
Class A Wiring
A-
A+
A/B-
A/B+
A-
A+
A/B-
A/B+
A-
A+
A/B-
A/B+
1
2
3
4
5
6
7
8
1
2
4
8
16
32
64
NO
B
WIRING
CLASS
A
1
0
SWITCH MONITOR 2
SWITCH MONITOR 1
1
2
3
4
5
6
7
8
1
2
4
8
16
32
64
NO
B
WIRING
CLASS
A
1
0
E
O
L
Class B Wiring
47K
1/2 Watt
E
O
L
Class B Wiring
47K
1/2 Watt
TB2
TB3
TB1
Figure 11 - 55000-790ADV Wiring
