ADTRAN ATLAS 800PLUS, User Manual

Page: 107 / 166

Chapter 6. Creating a Dedicated Map
61200226L1-1 ATLAS 800
PLUS
User Manual 6-3
2. Navigate to the
Port
index number of the second port and paste the
configuration by pressing P . Repeat for the first port of the T1/PRI card
located in Slot 1.
3. Navigate to the
V.35 Port Configuration
menu and repeat the configuration of
the first port followed by copy and paste to the second and third ports.
Implement the Map
1. Navigate to the
Dedicated Map
menu and select
Create /Edit Map
. If desired,
enter a name for the map by pressing Enter when the cursor is over
Map
Name
. Type the desired name in the entry box.
2. Select the
Connects
submenu. Using Table 6-1 on page 6-2, define each of the
connections necessary to route the bandwidth as desired. For the example,
there will be a connection for each of the connections shown in Table 6-1 on
page 6-2. The entries are made as follows (a completed map is shown in
Figure 6-3).
A. Select the
FROM Slot
for Data A (i. e., Controller T1).
B. Select the
FROM Port
(i.e. Port 1 for T1-A Data).
C. Using the
FROM Configuration
submenu select the DS0s (i.e. 9-24 for Data
A).
D. Select the
TO Slot
and
TO Port
the same way (V.35 in Slot2 / Port 1 for Data
A).
E. Using the
Configuration
submenu, set the V.35 to operate at 56k / 64k per
DS0.
F. Repeat for the remaining Data connections (i. e., Data B and Data C).
G. Insert new connection lines by typing I with the cursor over the
Index #
of
the first connection.
H. Copy the first connection by pressing C with the cursor on the
Index #
.
I. Paste this onto a new connection line by typing P with the cursor over the
index numbers of the new connections.
J. Modify these connection lines to complete the connections for data.
K. Select the
FROM Slot
and
FROM Port
for the first voice connection (i. e., Slot
0/Port 1 for T1-A Voice).
L. Repeat step C to select the voice DS0s (i. e., 1 through 8 for Voice A).
M. Select the TO slot/Port (PBX Connection) as in D above (i. e., Quad T1/
PRI in Slot 1/Port 2).
N. Using the
Configuration
submenu, set the starting DS0 that these voice
DS0s will appear in (i. e., 1 for Voice A; 9 for voice B; 17 for Voice C). This
sets the DACSing between the T1s.