ADTRAN ATLAS 800PLUS, User Manual

Page: 99 / 166

Chapter 5. Using the Terminal Menu
61200226L1-1 ATLAS
_
800
PLUS
User Manual 5-47
Called Digits Transferred
Write security: 3; Read security: 5
Defines to ATLAS the number of called-number digits to forward. When attached
to a PBX, the PBX may be provisioned to expect to receive fewer than all of the
called digits of the incoming call. This would normally be set to
All .
Outgoing Caller ID
Write Security: 3 Read Security: 5
This item allows the user to insert a called ID to be added to outgoing calls (com-
ing in from attached User equipment). If set to
Send as Provided
, then ATLAS
will forward whatever ID it receives (including none). If set to
Substitute if not
present
, then ATLAS will insert a User defined ID value if no value is received. If
set to
Substitute Always
, then ATLAS will always insert the User defined ID in
place of the value received.
ID Presentation
Defines control information for the presentation of
Caller ID
to be inserted:
( Presentation Allowed; Presentation Restricted; Number Not Available .)
ID Number
Value for
Caller ID
to be sent to the Network (i.e., 256 963 8020).
Source ID
The
Source ID
field simplifies the creation of a Dial Plan in applications where
the criterion for switching calls to a certain end point is a function of which
end point originated the call.
• Default value = 0. The default ID for all end points is 0 and all accept # s is
0. With default values, all calls are routed based only on dialed number.
• Multiple end points can have the same
Source ID
.
• When creating the Call Accept list, specify a
Source ID
(s) as well as a dialed
number or range of dialed numbers to accept.
Example:
An application requires that all calls originating from Port 1 of the Quad
T1/PRI module in Slot 1 be switched to Port 4 of that same module.
Assign a unique
Source ID
(e.g., 7) to Port 1 of the module, and then con-
figure Port 4 to only accept calls from that unique
Source ID
(7).
Swap ANI/DNIS
This option swaps the ANI and DNIS numbers prior to being forwarded to the
attached user equipment. ANI (Automatic Number Identification) is the billing
number of the calling party, and DNIS (Dialed Number Identification Service) is
the called party number.
This swap will occur after the ATLAS switchboard has routed the call. The accept
# in the dial plan must use the number in the DNIS position prior to swapping.