ADTRAN ATLAS 800PLUS, User Manual

Page: 86 / 166

Chapter 5. Using the Terminal Menu
5-34 ATLAS
_
800
PLUS
User Manual 61200226L1-1
ule type being used is not reflected in the Interface Configuration section, please
refer to the option module manual for information on the interface parameters.
Slot/Port
Write security: 3; Read security: 5
These fields are used to select the ATLAS port that terminates a Network con-
nection.
There may be more than one “end point” associated with a particular port. If a
T1 is connected to the PSTN, some DS0s may be used for long distance, while oth-
ers are used for local calls. These would constitute two “end points” (trunks) over
a single physical port.
Sig (Signalling)
Write security: 3; Read security: 5
Defines the type of signaling being used for this connection (end point). RBS
would be for a T1 using Robbed Bit Signaling while PRI designates a Primary
Rate ISDN interface. This selection is only necessary if a T1/PRI is selected as
the Slot/Port type.
Outgoing#Accept
Write security: 3; Read security: 5
This submenu defines the parameters for the outgoing calls that ATLAS sends
to the Network.
Source ID
Write Security: 3 Read Security: 5
This field identifies the ID of the call sources that this endpoint will accept
calls from. The Source ID field is used to simplify the creation of a Dial Plan
in applications where the criterion for switching calls to a certain endpoint is
a function of which endpoint originated the call.
Source ID may be entered with the usual wild card entries (except $)
Default value = 0. The default ID for all Source endpoint is 0 and all accept #'s
is 0. This results in all calls being routed based on the dialed number.
X
=
any digit 0—9
[1,3,5]
=
any of these digits