ADTRAN ATLAS 800PLUS, User Manual

Page: 95 / 166

Chapter 5. Using the Terminal Menu
61200226L1-1 ATLAS
_
800
PLUS
User Manual 5-43
ID Presentation
Sends to the Network control information for the presentation of Caller ID
(
Presentation Allowed; Presentation Restricted; Number Not Available .)
ID Number
Value for Caller ID to be sent to the Network( i.e. 256 963 8020).
Source ID
The
Source ID
field simplifies the creation of a Dial Plan in applications where the
criteria for switching calls to a certain end point is a function of which end point
originated the call.
• Default value = 0. The default ID for all end points is 0 and for all accept # s is
0. With default values, all calls are routed based only on dialed number.
• Multiple end points can have the same
Source ID
• When creating the
Call Accept
list, specify a
Source ID
(s) as well as a dialed
number or range of dialed numbers to accept.
Example:
An application requires that all calls originating from Port 1 of the Quad T1/PRI
module in Slot 1 be switched to Port 4 of that same module. Assign a unique
Source ID
(e.g., 7) to Port 1 of the module, and then configure Port 4 to only accept
calls from that unique
Source ID
(7).
Swap ANI/DNIS
This option swaps the ANI and DNIS numbers received from the Network. ANI
(Automatic Number Identification), is the billing number of the calling party, and
DNIS (Dialed Number Identification Service), is the called party number.
This swap will cause the ATLAS switchboard to use ANI to route the call.
The accept # in the dial plan must use the ANI number, not the DNIS num-
ber.
Quad T1/PRI Module (Network Termination/RBS)
When you are working in the Network Termination section of the Dial Plan menu,
the Slot is defined as a T1/PRI module, and Sig is set to RBS, the following inter-
face configuration options are available:
First DS0
Write security: 2; Read security: 5
Defines to ATLAS the DS0s which will be used for this endpoint. These are the
DS0s which ATLAS will use to send and receive calls to and from the Network
(PSTN). Outgoing calls which will be allowed or restricted over these DS0s are
set by the
Outgoing Call Accept
and
Reject Numbers
discussed earlier.
Number of DS0s
Write security: 3; Read security: 5
Specifies the number of DS0s already defined for this endpoint. This field is read-
only.