Adp Series 4000, Installation Manual

Page: 13 / 64

Determining Where to Install the Timeclock
Series 4000 Badge Timeclock Installation Guide 1-5
ADA Compliance Considerations
Consider the following for compliance with the Americans with Disabilities Act
(ADA). These are the regulations in effect at the time this documentation was
written; if you are in doubt about the regulations, ADP recommends that you
check the current ADA requirements.
!
Plan the installation so that when you mount the timeclock, the top two
mounting screws are no higher than 54 and 3/8 inches (138.09 cm) above the
floor. This ensures that no part of the timeclock that personnel will physically
use (badge reader, keypad) will be higher than the limit set by ADA.
!
Devices mounted on a wall must not protrude more than 4 inches (10 cm)
from the wall. You must mount the timeclock directly to the wall.
Environmental Considerations
Consider the following when deciding where to install the Series 4000 timeclock:
!
The timeclock is designed for mounting on walls in typical office and indoor
manufacturing environments. Recommended wall surfaces are drywall
(sheetrock) and wood.
!
The timeclock can withstand the following temperature and humidity ranges:
– Temperature ranges
Operating: 0 to 40 degrees Celsius (32 to 104 degrees Fahrenheit)
Storage: -20 to +70 degrees Celsius (4 to 158 degrees Fahrenheit)
– Humidity range (operating and storage): 10% to 95% non-condensing
!
Install the timeclock in an area where the timeclock screen is not exposed to
direct sunlight or other high-intensity lighting that could make the screen
difficult to read.
Adherence to Local Codes
Installation of the Series 4000 timeclock, including all electrical wiring, must
comply with all applicable national, federal, state, and local codes and standards.