Adp Series 4000, Installation Manual

Page: 25 / 64

Mounting the Base of the Timeclock
Series 4000 Badge Timeclock Installation Guide 2-9
2. If you are mounting the timeclock on wood , drill pilot holes for the mounting
screws. Use a drill or screwdriver to drive the top two mounting screws
(supplied with the timeclock) into the wall, leaving 1/4 inch (6 mm) between
the head of the screw and the wall.
If you are mounting the timeclock on drywall , do the following:
a. Use a 9/32 inch drill bit (7.1 mm) to drill holes for the wall anchors.
b. Install the wall anchors.
c. Install the top two screws, leaving 1/4 inch (6 mm) between the head of
the screw and the wall.
3. Align the top two screw holes in the base of the timeclock with the screws in
the wall, and gently set the base in position.
4. Tighten the top two screws.
5. Install and tighten the bottom screw to secure the base to the wall.
Note
Do not install the screws too tightly. If the wall surface is not smooth, you
could crack the housing by excessive tightening of the screws.