Adp Series 4000, Installation Manual, Page: 58 / 64

Appendix A Replacing a Series 400 Timeclock with a Series 4000 Timeclock
A-2 ADP, Inc.
Read This First
Before you replace an installed Series 400 timeclock with a Series 4000 timeclock
at your site, note the following information:
!
Remember to collect data from the Series 400 timeclock using your host
application before you disconnect the timeclock.
!
The Series 4000 timeclock supports Ethernet communication only; it does not
support modem, token ring, twin axial, RS-485, or RS-232 communications.
Therefore, do
not replace a Series 400 timeclock if it does not use Ethernet
communication and you want the timeclock at that location to continue using
one of the other methods.
!
The location of the mounting screw holes for both the Series 400 timeclock
and the Series 4000 timeclock are identical. You can install the Series 4000
timeclock in exactly the same location as the timeclock you are replacing.
However, ensure that the location satisfies the following requirements:
– To comply with the Americans with Disabilities Act (ADA), the top of the
timeclock cannot be greater than 54 and 3/8 inches (138.09 cm) above the
floor.
– If the Series 4000 timeclock will be plugged into a wall outlet away from
the timeclock (the timeclock is not mounted to cover an AC outlet), the
timeclock cannot be more than 5 feet (152.40 cm) away from the outlet.
Caution
If the Series 400 timeclock you are replacing uses an internal AC outlet, you must
have a licensed electrician disconnect the power line from the outlet.
Attention
Si le terminal de la série 4000 que vous remplacez est relié par une prise c.a.
interne, vous devez faire appel à un électricien agréé pour débrancher la prise de
la source d'alimentation.