Chapter 2 Installing the Series 4000 Timeclock
2-14
ADP, Inc.
Warning
Do
not
plug the power cord into the AC power source yet.
3. If you ran the power cord through the square cable access hole in the bottom
of the timeclock, use the supplied strain relief clip and screws to secure the
cord. Assemble the strain relief clip, nuts, and screws, as shown in the
following illustration.
If you did
not
use the square cable access hole in the bottom of the terminal to
run the power cable, cover the access hole using the square black plate and
two nuts that shipped with the terminal. To do this:
a.
Slip the square plate over the screw posts located at two corners of the
access hole.
b. Screw the two nuts onto the posts to secure the plate in place.
Summary of Contents for Series 4000
