Adp Series 4000, Installation Manual, Page: 19 / 64

Preparing the Location of the Timeclock
Series 4000 Badge Timeclock Installation Guide 2-3
1. Tape the mounting template at the desired height and location for the
timeclock. The top two mounting screws must be no higher than 54 and 3/8
inches (138.09 cm) above the floor, for ADA compliance.
2. Mark the location for the AC outlet and the mounting screw holes.
3. If you plan to run Ethernet cable through the wall to enter the timeclock from
the back, use the template to mark the point of entry.
4. Have a licensed electrician install the AC outlet.
5. If necessary, run the Ethernet cable through the wall and out the point of entry
into the timeclock. Provide 20 inches (50.8 cm) of slack.
Go to “Widening the Badge Reader Slot (optional)” on page 2-5 and then to
“Mounting the Base of the Timeclock” on page 2-8.
Preparing a Location to Use an Internal AC Outlet
1. Tape the mounting template at the desired height and location for the
timeclock. The top two mounting screws must be no higher than 54 and 3/8
inches (138.09 cm) above the floor.
2. Mark the location of the mounting screw holes.
3. If you will run an AC power line through the wall and into the timeclock,
mark the cable’s point of entry into the timeclock, as indicated on the
template.
You can also choose to run the AC power line externally, through conduit, and
in through the bottom of the timeclock. To do this, the AC power line must be
CL-2 or higher.
4. If you plan to run the Ethernet cable to enter the timeclock from the back, use
the template to mark the point of entry.
5. Run the AC power line and Ethernet cable to the timeclock location. For the
Ethernet cable, allow 20 inches (50.8 cm) of slack.
Go to “Widening the Badge Reader Slot (optional)” on page 2-5 and then to
“Mounting the Base of the Timeclock” on page 2-8. You will assemble and
connect the internal AC outlet after you install the base.