ADEMCO 8132, Installation And Setup

Page: 36 / 88

Symphony/Symphony-i Installation and Setup Guide
4-22
SCREEN ACTION
reset when the Reg/Test tab is pressed.
Allow the unit to restart and then navigate
back to the screen shown below to
complete AlarmNet-i registration.
12. If the ECP and IP Connection status
messages are green, press Please Register
and observe the message status queue. The
registration packet will be sent to AlarmNet
Central and acknowledged to complete the
registration process.
Registration complete.
Symphony/Symphony-i Setup
Setup allows you to adjust the touch screen contrast and/or adjust the Symphony/Symphony-
i speaker volume. You may also select the time interval that must pass prior to
Symphony/Symphony-i going into screen saver mode (screen goes blank). Additionally, you
may enter the
User Setup
screen,
Advanced Setup
screen, or
Clean Screen
(maintenance mode)
from the "Setup" screen by pressing the corresponding button.
Access the "Setup" screen as follows:
SCREEN ACTION
1. From the "Home" screen, press the
SECURITY button. The "Arming" screen is
displayed.