ADEMCO 8132, Installation And Setup

Page: 19 / 88

Section 4: Initial Setup
4-5
Symphony/Symphony-i ECP Addressing
After the Account Number has been set, the boot process will continue until the Set ECP
Address window is displayed.
SCREEN ACTION
If the system is incorporating only one
Symphony/Symphony-i, leave the address set
to 1 and press the OK button. The boot-up
process will continue until completion.
If there are to be additional
Symphony/Symphony-i units in the system,
refer to the
How to Change the ECP Address
paragraph.
How to Change the ECP Address
When the system contains two or more Symphony/Symphony-i units, it will be necessary to
assign a different ECP address to each unit. On residential control panels (Vista-20PS
or equivalent), two units may be used (addresses 1 and 2). These are automatically
enabled in the control panel.
On commercial control panels (Vista-128BP, Vista-128FBP or equivalent), up to six
units may be used, (addressed between 1-6). Address 1 is automatically enabled in the
control panel. Additional units will be inoperable until each address is enabled in the control
panel’s “Device Programming” mode. You can enable additional addresses in the control
panel using the unit set to address 1.
How to Enable Additional Symphony/Symphony-i Units in Commercial Controls (Vista-128BP,
Vista-128FBP or equivalent)
SCREEN ACTION
1. Press the SECURITY button on the “Home”
screen. The “Arming” screen is displayed.