ActionTec PC-250, User Manual

Page: 41 / 85

Installing the Software
PC-250, PC-260, and PC-300 User’s Guide Page 41
NOTE
Segment Address
These are the high-order 16 bits of the 20-bit
address, the segment address in x86 terms.
To accept the default starting memory address D000, press Enter .
To request a different address, type a hexadecimal number between
C000 and E000 at the Enter the Memory Window's Starting
Address: prompt and press
Enter .
5. INSTALL displays:
Enter the Memory Window’s Ending Address.
Accept the default ending memory address of DFFF if you accepted
the default starting address by pressing
Enter . If you entered
another starting address, enter a higher ending address between
CFFF and EFFF at the Enter the Memory Window's Ending
Address: prompt and press
Enter .
6. INSTALL advises you to manually exclude the memory range you
defined if you are using a memory manager other than EMM386,
386MAX or QEMM386. Refer to your memory manager
documentation for instructions.
Press any key to continue with the installation.
Completing Installation
INSTALL displays a list of the settings you have selected and gives you
a chance to change any of them. The following is a sample custom
installation listing:
The Card Reader with Microsoft’s Flash File System.
Destination directory C:\PCMCIA.
The drive is installed at I/O address 340.
The Card Insertion Annunciator is inactive.
Modem cards will appear as COM4 using IRQ9.
The user selectable I/O window is 320 - 32F.
The user selectable memory window is D000 - D7FF.
ATA drives will use address 180.