![background image](http://html1.mh-extra.com/html/actiontec/pc-250/pc-250_user-manual_2843226036.webp)
Installing the Software
Page 36
Selecting the Type of Card Reader
The next screen asks you to confirm the model of the Card Reader you
installed. INSTALL identifies the model number and highlights it for
you.
Press
Enter
to confirm the model number.
Selecting the I/O Base Address
The next screen prompts you for the Card Reader I/O base address and
displays the
default (240h).
WARNING
Switch Setting Compatibility
If you changed the switch setting, you must define
the I/O base address here. If the switch setting and
the software fail to match the Card Reader will not
work.
To accept the default I/O base address, press
Enter
. If you changed the
switch setting, enter the I/O base address between 200 and 360 at the
Enter Controller's Address: prompt and
press
Enter
.
If you wrote down the new I/O base address when you changed the,
refer to Chapter 2,
Installing the Hardware
, to confirm the new address
number.
Setting the ATA I/O Address
INSTALL asks if you wish to change the default I/O address used by
ATA (IDE disk) cards.
To accept the 170 default, press
Enter
. To change the address, enter a
different number between 100 and 200 at the Enter ATA Address:
prompt, and press
Enter
. The address must end in zero (0).
Summary of Contents for PC-250
Page 32: ......