Installing the Hardware
Page 26
1. lign the red stripe and connector key on the cable whose end is
labeled
DRIVE
with
pin 1
on the Card Socket Module connector
labeled
DRIVE
, and connect the cable.
2. Align the red stripe on the cable whose end is labeled
DRIVE
with
pin 1
on the Card Socket Module connector labeled
DRIVE
, and
connect the cable.
3. Install the Card Socket Module, including the connected ribbon
cables, into the PC drive bay. Exactly how to install the module in
the bay depends on your computer. Refer to your computer owner’s
manual or ask your dealer for assistance.
4. Attach the unit to the chassis with as many screws as will fit. You
need at least three for stability.
WARNING
Grounding the Module
Two of the screws must connect the metal of the
module and the metal of the bracket (if attached) to
the metal of the chassis. This grounds the unit so
that if your body is carrying a static electrical charge
when you insert a PC Card, the unit will be able to
discharge the static electricity without damaging its
components.
Summary of Contents for PC-250
Page 32: ......