ACS ACS-24UHF/Eagle, User Manual

Page: 7 / 239

7
1. Introduction to the ACS-24UHF
1.01 Unpacking

Verify that you have received all contents. There is a checklist in Section 1.02 . Please notify your ACS
supplier immediately if anything is missing.

Remove any plastic zip ties, foam pieces, or other packaging before turning on the ACS-24UHF.

The ACS-24UHF and other computer-
connected cutters are not “plug and play” devices. Be sure to follow
the installation directions carefully and make all recommended settings before operating.

Use the enclosed pen and pen holder during at least the first day of operation as you become familiar with
operating the ACS-24UHF. Place scrap paper into the cutter and simply draw images rather than cut them.
This will prevent possible damage to the blade, mat, and cutting strip as you learn where images will cut and
the basic operating procedures.

DO NOT unplug the USB cable from your computer or from the cutter unless you first turn off the cutter.
Doing so can cause power fluctuations that, in turn, can damage the cutter.

Always turn off the ACS-24UHF when not in use. Leaving the cutter turned on for extended periods of time
can possibly damage the machine.
1.02 Contents of Box
Please verify that you have received the following items. If anything is missing, please contact your ACS
supplier as soon as possible.

ACS-24UHF Cutter

Cutting Mat

Blade Holder

Spray Adhesive for Mat

Two blades (45 degree and 60 degree)

Bolt-on Tables

Testing Pen Holder with 2 pen inserts

Screws and screwdriver for bolt-on tables

User Manual in PDF format

Power Cord, Serial Cable USB Cable


1.03 Items to Note

Power Ratings: 110-240 VAC, 50-60 Hz, 1.0-2.0 A

Power Supply: The ACS-24UHF
’s power supply is 110V-240V. If your supply is different from this, please
use a power converter. Remove the power cable if the cutter will not be in operation for a significant
length of time.

Connecting to Your Computer: You have the option of connecting via the RS232 serial port OR via the
USB port. Your shipment contains both a USB cable and a serial cable, although your computer may not
have a serial port installed.

Blades: The blades used by cutters are extremely fragile. Do not drop or even bump the blade onto any
hard surface as they can chip easily. When not in use, retract the blade into the blade holder or remove
and cover the sharp end with the soft plastic cap.

Transporting: When transporting the cutter, move the pinch wheel levers into the upward position.
Remove the accessories from the tool tray and place in a separate bag. We also recommend retaining
the original box with the Styrofoam inserts in case you ever need to ship your ACS-24UHF.

Additionally:
o
DO NOT touch or jam the plotter’s track while it is operating. If the cutter is damaged, it is the
owner’s responsibility.