ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
32
30
9. Sensor alignment offset / final value
9. Sensor alignment offset / final value
The device is equipped with a semi-automatic sensor calibration (
Su.xxx
). A switching output operates the
trimming resistor, which exists in some sensors. An adjustment of offset and final value takes place, after
which the sensor can be used directly. Depending on parameterisation, the calibration can be realized via
the 4th key or via the digital input. It is possible to key during the calibration steps. So, reference signals can
be connected manually. However the calibration will be interrupted after 30 seconds.
Press actuator for minimum 3
seconds.
For minimum 1 measuring cycle, minimum
1s or maximum per actuator.
Current measuring range
value, e.g.
0.061
For minimum 1 measuring cycle
or with actuator.
For minimum 1 measuring cycle, minimum 1s
or maximum per actuator.
Current measuring range value.
Switch-off/switch-on optional
switching output, e.g. 7,132
For minimum 1 measuring cycle,
minimum 1s or maximum per
actuator.
Optional: switch-off switching output and
display for minimum 1 measuring cycle or
minimum 1s holding time.
Back to regular operation mode.
For calibration
problems or 30
seconds
holding time.
Back to regular operation mode,
after 1s or 1 measuring cycle.
Activate optional switching
output.
For calibration
problems or 30
seconds
holding time.
