ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
16
5. Setting up the device
14
Zero point slowdown,
ZErO:
Default:
00
At the zero point slowdown, a value range around the zero point can be preset, so the display
shows a zero. If e.g. a 10 is set, the display would show a zero in the value range from -10 to
+10; below continue with -11 and beyond with +11. The maximum adjustable range of value is
99.
Definite contstant value,
const
:
Default:
0
The constant value can be evaluated via the alarms or via the analog output, like the current
measurand. The decimal place cannot be changed for this value and is taken over by the
current measurand. Like this a setpoint generator can be realised via the analog output by this
value. Furthermore it can be used for calculating the difference. At this the constant value is
substracted from the current measurand and the difference is evaluated in the alerting or by the
analog output. Thus regulations can be displayed quite easily.
Minimum constant value,
con.mi
:
Default:
-i9999
The minimum constant value is adjusted from the smallest to the highest digit with the
navigation keys
[
▲
] [
▼
]
and confirmed digit per digit with
[P]
. A minus sign can only be
adjusted on the highest digit. After the last digit the display changes back into menu level.
Maximum constant value,
con.ma
:
Default:
99999
The maximum constant value is adjusted from the smallest to the highest digit with the
navigation keys
[
▲
] [
▼
]
and confirmed digit per digit with
[P]
. A minus sign can only be
adjusted on the highest digit. After the last digit the display changes back into menu level.
Display,
dISPL:
Default:
actua
With this function the current measuring value, min/max value, totaliser value or the process-
controlled Hold-value can be allocated to the display. With
[P]
the selection is confirmed and
the device changes into menu level.
Parameterisation level
Menu level
