ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
18
5. Setting up the device
16
Special function [O]-key,
tASt.4:
Default:
no
For the operation mode, special functions can be deposited on the
[O]-
key. This function is
activated by pressing the key. With
tArA
the device is set temporarily on a parameterised value.
The device acknowledges the correct taring with
oo0oo
in the display.
Set.tA
adds a defined
value on to the currently displayed value. Via
totAL
the current value of the totaliser can be
displayed for approx. 7 seconds, after this the device switches back on the parameterised
display value. If
tot.rE
is deposited, the totaliser can be set back by pressing of the navigation
keys
[
▲
] [
▼
]
, the device acknowledges this with
ooooo
in the display.
EHt.rE
deletes the
min/max-memory. If
HOLD
has been selected, the moment can be hold constant by pressing the
[O]-
key, and is updated by releasing the key.
Advice:
Hold
is activated only, if
HOLD
was
selected under parameter
DISPL
.
ActuA
shows the measuring value for approx. 7 seconds, after
this the device switches back on the parameterised display value. The same goes for
AVG
, here
the sliding average values will be displayed. At
AL-1
…
AL-4
an output can be set and therewith
e.g. a setpoint adjustment can be done. If
no
is selected, the
[O]-
key is without any function in
the operation mode.
Special function digital input,
dIG.In:
Default:
no
In operation mode, the above shown parameter can be laid on the optional digital input, too.
Function description see
tASt.4
.
Back to menu group level,
rEt
:
With
[P]
the selection is confirmed and the device changes into menu group level
„–fct–“
.
Parameterisation level
Menu level
…
…
