ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
12
5. Setting up the device
10
Setting up the display time,
SEC
:
Default:
1.0
The display time is set with
[
▲
] [
▼
]
. The display moves up in increments of 0.1 up to 1 second
and in increments of 1.0 up to 10.0 seconds. Confirm the selection by pressing the
[P]
button.
The display then switches back to the menu level again.
Setting the decimal point,
dot
:
Default:
0
The decimal point on the display can be moved with
[
▲
] [
▼
]
and confirmed with
[P]
. The
display then switches back to the menu level again.
Rescaling the measuring input values,
EndA:
Default:
10000
With this function, you can rescale the input value of
e.g. 55 mV
(works setting) without
applying a measuring signal. If sensor calibration has been selected, these parameters are not
available.
Setting up the start/offset value of the measuring range,
offs
:
Default:
0
Enter the start/offset value from the smallest to the highest digit with
[
▲
] [
▼
]
and confirm each
digit with
[P]
. After the last digit the display switches back to the menu level. If
Sens
was
selected as input option, you can only select between
noca
and
cal.
With
noca
, only the
previously set display value is taken over, and with
cal
, the device takes over both the display
value and the analogue input value.
Setting the end value of the measuring range,
END
:
Default:
10000
Set the end value from the smallest to the highest digit with
[
▲
] [
▼
]
and confirm each digit with
[P]
. A minus sign can only be parameterized on the highest value digit. After the last digit, the
display switches back to the menu level. If
Sens
was selected as input option, you can only
select between
noca
and
cal.
With
noca
, only the previously set display value is taken over, and
with
cal
, the device takes over both the display value and the analogue input value.
Parameterisation level
Menu level
then
