10 OMNISTIM
®
500A USER MANUAL
COPYRIGHT 2001 - 2007, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
CONFIDENTIAL AND PROPRIETARY
Q.
Output for channel “B” in IFC, MFAC and LVPC modes.
R.
Output for channel “A” in IFC, MFAC and LVPC modes.
S.
Lead wire adapter – 3 pin.
T.
Super twist LCD graphics display for all functions and parameters. The graphics screen allows display of:
•
Modality selected
•
Program selected
•
Time remaining
•
Bar graph for timing
•
On-Off time, delay and ramps
•
Beat frequency and sweep ranges
•
Sweep rate and modulation selection
•
Burst or pulse frequency
•
Phase duration and interphase interval
•
Output voltage or current
•
Vector selection
•
Battery condition
•
Display contrast
•
Button speeds and delay
Factory Settings
The
OMNISTIM
®
500 comes with the following factory settings:
Button Speed, A & B Output
87
Button Speed, Beat, etc.
93
Button Delay, all
40
Audio
ON
Screen Contrast
5
These are generally suitable for most clinicians. To adjust these default settings proceed as follows:
1.
When the main screen comes up and states “SELECT MODALITY/PROGRAM” push the SELECT
PARAMETERS button repeatedly to display the factory settings. You will then be able to adjust the
selected factory settings by pressing the TIME/PARAMETER up/down button. The new settings will be
saved from use to use as long as you do not remove the batteries or allow a full discharge of the unit.
2.
The screen contrast sets the appropriate viewing angle for easy screen legibility.
3.
The button speed for output A & B sets the speed at which output will increase and decrease when you
push the buttons. This should generally be set at a slower speed (80 - 90) so as not to startle the patient.
4.
The Button speed BEAT Etc. controls the scrolling speed of all of the remaining buttons on the system. A
speed of 90 to 95 is typical if you have good coordination and hand control.
5.
The button delay represents the amount of time that you have to push and hold the buttons down before
they will begin to increment automatically at the button speed. The smaller the number the faster the
response time.
6.
Audio on or off disables or enables the audio system that beeps at the end of the treatment and during the
NMES programs.
NOTE:
The factory settings cannot be accessed during operation and are only available following the start
up screen. The settings will reset to their initial default parameters if the batteries are removed or the unit
is fully discharged. To restore the new settings follow the procedure in Appendix I.
