©2018 ACP, Inc.
Cedar Rapids, IA 52404
Page 68 of 80
Part No. 16400033
Original Instructions
Convection Motor
Convection Motor
The convection motor turns a fan that creates the air movement for impingement cooking
⚠
CAUTION
Extreme care must be taken when performing tests with line voltage applied.
Testing
Disconnect Connector ST2
Apply Line Voltage
Test voltage between ST1-1 and ST1-2
If Line Voltage is present and Motor does not run, replace Motor
Removal and Replacement
1 Disconnect oven from Power Supply
2 Remove Top, Right, Left and Rear Panels (see Panel Removal)
3 Remove Rear Exhaust Duct (see Rear Exhaust Duct Removal)
4 Remove four (4) Screws securing component Mounting
Bracket Remove two (2) Screws joining each half of
Bracket Move each side out of the way Remove Wires
as needed noting their locations
5 Disconnect Electrical Connectors to Motor
6 Remove Fiberglass Tape from around perimeter of
Mounting Plate
7 Remove insulation or fold back to expose Mounting
Screws around perimeter
8 Disconnect Wires to Heater
9 Remove sixteen (16) Screws using 1/4” Socket
10 Pull the assembly out
11 The replacement part is an assembly
• P/N 59174583 (includes Heater)
12 To replace, reverse these steps
⚠
CAUTION
