©2018 ACP, Inc.
Cedar Rapids, IA 52404
Page 60 of 80
Part No. 16400033
Original Instructions
Wave Guide
Wave Guide
⚠
DANGER
All High Voltage Capacitors must be discharged before performing this procedure.
The Wave Guide channels the microwaves generated by the Magnetron into the cooking chamber
Removal and Replacement
1 Disconnect oven from Power Supply
2 Remove Top, Right, Left and Rear Panels
(see Panel Removal)
3 Discharge HV Capacitors
4 Remove Rear Exhaust Duct
(see Rear Exhaust Duct Removal)
5 Remove Magnetron (see Magnetron Removal)
6 Remove Stirrer Motor (see Stirrer Motor Removal)
7 Remove the Stirrer Motor Mounting bracket by removing
four (4) 11/32” (9mm) Hex Nuts Lift up and out
8 Remove 11/32” (9mm) Hex Nuts on each side of Wave
Guide
9 Inside the oven, remove the Top Forced Air Plate by
removing four (4) Phillips Head Screws in each corner
10 Loosen, but do not remove, four (4) Phillips Head
Screws securing the toggles securing the Microwave
Window Gently pry the Microwave Window down to
release the Foam Gasket
11
Remove the Antenna Gear by first removing the oblong
Keeper, then pressing firmly on the Split Shaft with a
1/4” Socket. Lift Gear up and off.
12 From inside the oven chamber, remove the four (4)
1/4” Hex Nuts from around the Antenna
13 Pull the Antenna down and remove
14 To replace, reverse these steps
⚠
DANGER
7
8
11
12
