Acme Packet Net-Net 6300, Hardware Installation Manual

Page: 62 / 116

58 Net-Net 6300 Hardware Installation Guide Version 1.0
SYSTEM INSTALLATION
2. Insert the duplex LC connector on the end of the fiber cable into one of the SFP+
optical transceivers. The connector should click and lock in place when you
insert it properly. The media and signaling ports from left to right bottom to top
are labeled:
P0 & P1 on each NIU . The image below shows Multi Mode cable.
3. Route the cable away from the Net-Net 6300. Make sure that the fiber optic
cables are not stretched tightly or subjected to extreme stress. The image below
shows a Net-Net 6300 with media network cables properly connected and
inserted in
P0 & P1 . The image below shows Single Mode cable.
4. Repeat Steps 1 through 2 for each additional fiber optic cable you connect to
your Net-Net 6300.
Cabling for HA Deployments
The information and instructions in this section explain how to cable an HA node.
HA Cabling
Category 5 (or higher) shielded Ethernet cables are required for cabling two HA
nodes together.
Rear Panel Cabling You can use one or two connections for HA redundancy support between the two
members of an HA node. Using two rear interfaces for sharing redundancy
information provides a high level of reliability. As a rule, Mgmt0 should be reserved