Acme Packet Net-Net 6300, Hardware Installation Manual

Page: 46 / 116

42 Net-Net 6300 Hardware Installation Guide Version 1.0
SYSTEM INSTALLATION
5. Secure the 10-32 screw to the nut bar you are holding in place. Refer to the
following exploded view of procedure:
Do not completely torque the screws; leave a small amount of play at this point.
6. Repeat Steps 3 - 5 for the other mounting point.
7. Repeat this procedure for the other stationary slide
To install the stationary rails on the rear of a square hole equipment rack:
Note: The images used in this procedure refer to the stationary slide
without slide extenders installed. The procedure is essentially the same
with the slide extender’s flange placed on the outside of the rear rack
rail.
1. Locate the following components:
• 6 x 10-32 x 5/8” screws
•
2 x nut bar
2. Expand and line up the unpainted side of the stationary rail ear on the outside
of the rear rack rail at the height used for the front mount point.
3. Hold the nut bar behind the rear rack rail.