8
6.4 Altitude
Operating:
1. 12,000 feet @ 25°C (3.5 hours)
2. Altitude Ramp rate: <= 3500 feet per minute (1 hour)
Non-operating:
40,000 feet @ -30 °C (1 hour)
Safety
X1130/X1230/X1230S :
CB, GS, UL, CUL, PSE, CCC
X1235/X1230K :
CB, GS, UL, CCC
EMC
X1130/X1230/X1230S :
CE, FCC, VCCI
X1235/X1230K :
CE, FCC
7.0 Regulatory
ESD
8.0 Reliability
8.1 MTBF
40000 hours except DMD chip, Color wheel, Lamp, Fan and
Ballast
8.2 Lamp Lifetime
Normal : 3000 hours (50% brightness maintenance)
Eco: 4000 hours
9.0 Power Requirements
Adhere to Section “Power Supply Specification”
9.1 Power Supply
(Normal)
VAC 100 – 240 (50/60Hz),
Typical
X1130/X1230/X1230S/X1230K :
280W Max.
X1235 :
285W Max.
9.2 Power consumption
Standby
5W Max.
(X1235/X1230K :loop through is
disabled)
9.3 Power Connector
IEC-06
10.0 Panel Specification
10.1 Type
X1130 : 0.55” SVGA LVDS Type-X DMD
X1230/X1230S
/X1235
: 0.55” XGA 2xLVDS Super Value
Type-X DMD
X1230K : 0.55” XGA 2xLVDS Super Value Type-X DMD
10.2 Pixels
X1130 : H: 800 X V: 600
X1230/X1230S
/X1235/X1230K
: H: 1024 X V: 768
10.3 Color Depth
24 Bits (16770000 colors)
11.0 Compatibility
Adhere to Section “Electrical Specification”
11.1 PC
PC Compatible 640X480
1024X768, compressed
1920X1080; Composite-Sync; Sync-on-Green
11.2 Video
NTSC/ NTSC4.43/ PAL (Including PAL-M, PAL-N)/ SECAM/
PAL60/
11.3 YpbPr
NTSC (480i)/ 480p/ PAL (576i)/ 576p,
HDTV (720p/1080i/ 1080p)
11.4 DDC
EDID 1.3
12.0 Image Interface
Adhere to Section “Electrical Specification”
12.1 Analog RGB Input
15 pin D-Sub (Female) x 1
G(Y): Video amplitude 0.7/1.0 Vp-p : Impedance 75
Ω
RB(CbCr): Video amplitude 0.7 Vp-p : Impedance 75
Ω
HD/VD/CS: TTL Level
12.2 Video Input
RCA jack (Yellow)
Summary of Contents for X1130 Series
