ABB STT04, Instruction Manual

Page: 240 / 285

STT04 DOWNLINK SOFTWARE
USING DOWNLINK SOFTWARE
O - 11
3. Place the STT04 terminal into the remote mode. Refer to
UPLOADING AND DOWNLOADING CONFIGURATIONS in
Section 4 for details.
4. Click Transfer Configurations and select Download to STT04 . A
summary of configurations appears similar to the screen in Figure
O-4 .
5. Highlight the desired configurations from the computer database.
Click to select only the configurations you want. Do this until all
the desired configurations are selected.
- or -
Click Select All to select all configurations from in the computer
database (Fig O-4 ).
NOTE: If a configuration already exists, DownLink software prompts
to replace the existing configuration and indicates if it has changed
in the field (Fig.
O-5 ).
6. Click the arrow key to identify the configuration(s) for transfer (Fig
O-4 ).
NOTE: The select box (in the center of the screen) holds the config-
urations that will be transferred to the STT04 terminal.
7. Click Transfer . The selected configurations are downloaded to the
STT04 terminal.
Utilities
The following subsections describe the menu items of the Utilities
selection.
TEST COMMUNICATION
Use this function to verify communications and the physical connec-
tion between the STT04 terminal and the personal computer.
1. Connect the STT04 terminal to the personal computer.
a. Connect the female end of the RS-232-C cable to a vacant
RS-232-C port (serial port) on the personal computer.
b. Connect the male end of the RS-232-C cable to the STT04
terminal.
2. Start the DownLink software. Refer to Start located in this sec-
tion.