![background image](http://html1.mh-extra.com/html/abb/relion-sam600-io/relion-sam600-io_operation-manual_3395302038.webp)
5.1.9.1
Editing numerical values
AMU0600415 v14
1.
Select
Main menu /Settings
and then a setting.
The last digit of the value is active.
IEC17000244-1-en.vsd
IEC17000244 V1 EN-US
Figure 21:
Last digit is active and it can be increased or decreased
2.
Press
to increase or
to decrease the value of an active digit.
One press increases or decreases the value by a certain step. For integer values, the change
is 1, 10, 100 or 1000 (...) depending on the active digit. For decimal values, the change can be
fractions 0.1, 0.01, 0.001 (...) depending on the active digit.
For parameters with defined steps, digits smaller than the step value cannot be
edited.
3.
Press
or
to move the cursor to another digit.
4.
To select the minimum or maximum value, select the arrow symbol in front of the value.
•
To set the value to the maximum, press
.
•
To set the value to the minimum, press
.
If the value is already at either end value (minimum or maximum), it requires two presses to
change it to the opposite end value.
After pressing
, the previous value can be restored by pressing
once, and vice versa.
Another press of
or
sets the value to the lower or higher limit. The symbol in front of the
value is ↕, when the previous value is shown.
Section 5
1MRK 500 131-UEN Rev. C
Using the HMI
32
Switchgear control unit SAM600-IO
Operation manual
© 2017 - 2021 Hitachi Power Grids. All rights reserved