Section 5
Using the HMI
5.1
Using the local HMI
GUID-235278D0-97C9-4F0F-A521-C7DFA8600C4E v7
At delivery, logging on is not required and the user has full access until users and passwords are
created with PCM600 and written into the IED or Centralized Account Management is enabled.
Commands, changing parameter values and resetting indications, for example, are actions requiring
password when the password protection is activated. Reading information on the LHMI is always
allowed without password.
Utility security policies and practical consideration should always be taken on the
feasibility of using passwords. In emergency situations, the use of passwords could
delay urgent actions. On the other hand when security issues must be met, the two
factors must be seriously considered.
Do not switch off the auxiliary power supply to the IED before changes, for example,
setting parameter or local/remote control state changes are saved.
IEC13000282-1-en.vsd
GUID-6B1C3B17-FFD1-4D3C-A50B-29524361C368 V1 EN-US
Figure 7:
Saving changes animation
Parameter saving is indicated by an animation in the lower right of the screen. As long as this
animation is shown, saving is in progress.
5.1.1
On-screen keyboard
GUID-725842B8-0941-4591-B724-71F016B21C1A v2
The on-screen keyboard is a three-row button pad where all the visual ASCII characters are
selectable buttons. The editing location is marked with a cursor.
IEC13000250-1-en.vsdx
IEC13000250 V1 EN-US
Figure 8:
On-screen keyboard
•
To insert a character navigate to the desired character in the middle three key rows with
,
,
and
and confirm each character with
.
•
To delete a character press
or use the Backspace key on the on-screen keyboard.
•
To clear a whole string press
and then
.
1MRK 500 131-UEN Rev. C
Section 5
Using the HMI
Switchgear control unit SAM600-IO
25
Operation manual
© 2017 - 2021 Hitachi Power Grids. All rights reserved