![background image](http://html1.mh-extra.com/html/abb/relion-rec670/relion-rec670_commissioning-manual_3377470022.webp)
•
the character ^ in front of an input/output signal name indicates that the
signal name may be customized using the PCM600 software.
•
the character * after an input signal name indicates that the signal must be
connected to another function block in the application configuration to
achieve a valid application configuration.
•
Logic diagrams describe the signal logic inside the function block and are
bordered by dashed lines.
•
Signals in frames with a shaded area on their right hand side represent
setting parameter signals that are only settable via the PST or LHMI.
•
If an internal signal path cannot be drawn with a continuous line, the suffix
-int is added to the signal name to indicate where the signal starts and
continues.
•
Signal paths that extend beyond the logic diagram and continue in another
diagram have the suffix ”-cont.”
1.5
IEC61850 edition 1 / edition 2 mapping
Table 1:
IEC61850 edition 1 / edition 2 mapping
Function block name
Edition 1 logical nodes
Edition 2 logical nodes
AEGPVOC
AEGGAPC
AEGPVOC
AGSAL
AGSAL
SECLLN0
AGSAL
ALMCALH
ALMCALH
ALMCALH
ALTIM
ALTIM
ALTMS
ALTMS
ALTRK
ALTRK
BCZSPDIF
BCZSPDIF
BCZSPDIF
BCZTPDIF
BCZTPDIF
BCZTPDIF
BDCGAPC
SWSGGIO
BBCSWI
BDCGAPC
BRCPTOC
BRCPTOC
BRCPTOC
BRPTOC
BRPTOC
BRPTOC
BTIGAPC
B16IFCVI
BTIGAPC
BUSPTRC_B1
BUSPTRC
BBSPLLN0
BUSPTRC
BUSPTRC_B2
BUSPTRC
BUSPTRC
BUSPTRC_B3
BUSPTRC
BUSPTRC
BUSPTRC_B4
BUSPTRC
BUSPTRC
BUSPTRC_B5
BUSPTRC
BUSPTRC
BUSPTRC_B6
BUSPTRC
BUSPTRC
BUSPTRC_B7
BUSPTRC
BUSPTRC
Table continues on next page
Section 1
1MRK 511 360-UEN A
Introduction
16
Bay control REC670 2.1 IEC
Commissioning manual