ABB IRT 710, Product Manual

Page: 333 / 384

Refitting the fixed chain end
Note Action
Note
If any part of the cable chain tray has been re-
moved, use Loctite 243 when refitting parts. Also
note that the NYLOC nuts can only be used once.
1
Refit the fixed chain end with bracket to the cable
chain.
Note
Be careful with the cables routing.
2
Replacing the inner cable chain link
on page 295 Refit the cable chain link besides the fixed chain
end. 3
Replacing the outer cable chain
link on page 288
Refit the plastic link bars. 4
Pull the cables from outer side and route the
cable. 5
xx2200000888
Refit the fixed chain end with cables to the car-
riage and secure with screws. 6
Screws: ISO 4762 M6x20 Class 8.8
(4 pcs)
Washers: BN 792 M6 Washer (4
pcs)
Tightening torque: 10 Nm
Fix the cables with straps on the cable chain ac-
cording to the photo taken before the replacement. 7
Run a few strokes in jogging mode and check that
the chain is gliding properly upon itself and is
correctly adjusted sideways. 8
Continues on next page
Product manual - IRT 710 333
3HKA00000186299-001 Revision: B
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.4.2.6 Replacing the cables in cable chain
Continued