Before installing the breaker, the secondary
disconnects must be wired to the Emax 2
Retrofill Breaker.
Wires with wire markers are provided on the
breaker. Make sure that the switchgear
wiring connection points match up with the
original wiring of the cubicle. This ensures
that all wiring connections are properly
made.
Wrong connections will cause the breaker to
malfunction.
WIRING
Notice
AKD-10: Install Accessories
This section deals with installing and wiring the legacy secondary disconnect assemblies
onto the Emax 2 Retrofill breaker. Installing the secondary disconnect assembly consists
of doing these tasks:
Figure 36
AKD-10 Secondary Disconnects View 1
26 - AKD-10: Secondary Disconnects
Installing the secondary disconnect assembly (Figure 36, Figure 37, and
Figure 38).
Wiring the secondary disconnect assembly (Table 6 shows the WavePro
secondary disconnect terminals).
The Emax 2 Retrofill Breaker has these three options:
One secondary disconnect installed
Two secondary disconnects installed
No secondary disconnects installed
NOTE: Wires shall be routed below the vented cover (Fig. 36) and wire tied to the
side
frames, do not route wires over arcchutes, allow slack in wires so secondary
disconnect sits level and lifted by the spring washer (Fig. 38).
C
Summary of Contents for AKD-10
