The primary disconnect assembly is factory-adjusted to apply a 95 + 10 lb. force to
a 1/2-inch thick copper bar, inserted between the upper and lower fingers. Set this
force range, in the field, by tightening the nuts to set the spring dimension shown
in Figure 44/45. Note that this dimension is measured between the top of the
retainer and the underside of the washer.
Also note that no bar is inserted between
the fingers when setting this dimension.
Figure 46/47 shows the cluster
components.
Adjustment - 3200A (Double Spring)
Cluster Components - 3200A
Figure 44
Figure 45
Figure 46
Adjustment - 4000A & 5000A
C
Summary of Contents for AKD-10
