ABB ACS880-77CC, Hardware Manual

Page: 95 / 128

Applicable standards
The converter complies with the standards below. The compliance with the European
Low Voltage Directive is verified according to standards EN 61800-5-1.
Safety of machinery. Electrical equipment of machines. Part 1: General require-
ments. Provisions for compliance: The final assembler of the machine is responsible
for installing
• EN 60204-1:2006 +
A1:2009 + AC:2010
- an emergency-stop device.
Degrees of protection provided by enclosures (IP code)
• EN 60529:1991
Low-voltage switchgear and controlgear assemblies
• IEC 61439:2020
Wind turbines. Part 1: Design requirements
• IEC 61400-1:2019
Adjustable speed electrical power drive systems. Part 3: EMC requirements and
specific test methods
• IEC 61800-3:2017,
EN 61800-3:2004 +
AMD1:2012
Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy.
• EN 61800-5-1:2007,
IEC 61800-5-1:2007 +
AMD1:2016
Requirements for electrical installations
• BS7671
Safety requirements for power electronic converter systems and equipment - Part
1: General
• IEC 62477-
1:2012/AMD1:2016
Adjustable Speed Electrical Power Drive Systems - Part 5-1: Safety Requirements
- Electrical, Thermal and Energy. See section
ETL marking (page 97) .
• UL 61800-5-1
Power conversion equipment
• CSA C22.2 NO.
107.1:16
CE marking
A CE mark is attached to the converter to verify that the converter follows the provisions of
the European Low Voltage Directive 2014/35/EU (previously 2006/95/EC) and EMC Directive
2014/30/EU (previously 2004/108/EC).
￭
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to
standard EN 61800-5-1.
￭
Compliance with the European EMC Directive
See section Compliance with EN 61800-3:2004/A1:2012 (page 96) .
UKCA mark
UKCA (UK Conformity Assessed) mark
Product complies with the applicable United Kingdom’s legislation (Statutory Instruments). Marking
is required for products being placed on the market in Great Britain (England, Wales and Scotland).
Compliance with the European Machinery Directive
Note: In standard texts, the term 'drive' stands for 'converter' in case of wind turbine
applications.
Technical data 95